Machine Options

Whether you need a new machine or you want to refurbish your existing machine, this form will help us understand exactly what you need


Please use your company email address if this is a commercial inquiry

Machine Details


Machine Dimensions


The frame is a rigid welded steel square tubing frame. The control panel is floor-standing and is not included in the above sizes

Gantry height is the maximum material height that can be cut by the machine, and it increases in increments of 100mm. The rigidity of the machine is conversely affected be the height of the gantry.

Gantry height is the maximum material height that can be cut by the machine, and it increases in increments of 100mm. The rigidity of the machine is conversely affected be the height of the gantry.

Control Gear


Dust Extraction Management


Standard and hold-down dust feet require existing dust-collection system and 6-bar compressed air.

Spindle


Table


* Unicam South Africa design Tufnol vacuum table is supplied with valves that control the area that vacuum is applied to. A vacuum gauge is fitted onto the supply manifold to assist with vacuum loss analysis.

* Unicam South Africa design Tufnol vacuum table is supplied with valves that control the area that vacuum is applied to. A vacuum gauge is fitted onto the supply manifold to assist with vacuum loss analysis.

* Unicam South Africa design Tufnol vacuum table is supplied with valves that control the area that vacuum is applied to. A vacuum gauge is fitted onto the supply manifold to assist with vacuum loss analysis.

Guide Options


Vacuum Generator


Drive Components


All Linear rails are of the square type and are 20mm.
Control is done with a CS Labs 6 axis CNC controller, and incorporates machine geometry correction.

All Linear rails are of the square type and are 20mm.
Control is done with a CS Labs 4 axis CNC controller.

Greasing System


Lubricating & Cooling


Auxillary


A complimentary starter tool kit is supplied: 1 X collet (supplied with Spindle), 1 cutter  and spanners required for spindle

A complimentary starter tool kit is supplied: 5 spare hot-wires &  allen keys

Hardware


Hotwire options


Commissioning, transport & training


Commissioning will take one day and is included in the cost of the retrofit.
Transport of equipment from your factory to our factory and back again (if required), is for the buyers account.

  • Commissioning will take one day and is included in the cost of the machine. (Value R 4 000.00)
  • Training will be done for a maximum of two days. Please inquire about cost of further training if needed.
  • Transport of the machine from our factory to your factory will be for the buyers account.

Wish to receive deep-cut discounts on Cutters and Machines?